Woodruff keyseat cutter 10,5X2 mm GARANT

Description

Version: Peripheral cutting, alternate set teeth (staggered). The sides of the teeth are ground to give clearance and thus cannot jam in the component. Special surface treatment. Application: Suitable for: • 70 m/min cutting speed (vc) in aluminium cast alloys < 10% Si up to 600 N/mm2, short chipping aluminium, low alloy copper up to 400 N/mm2. • 35 m/min cutting speed (vc) in general structural steels up to 500 N/mm2. • 28 m/min cutting speed (vc) in unalloyed quenched and tempered steels up to 750 N/mm2, unalloyed case-hardening steels up to 750 N/mm2, nitriding steels up to 750 N/mm2. • Free cutting steels, free cutting stainless steels, aluminium and non-ferrous metals. • Applicable with emulsion with at least 4 % grease content (for tapping at least 8 %). Note: For milling Woodruff keyways to DIN 6888 or for milling small slots.