Ball Nose Burr, Uncoated, Cut 6 – Double Cut, 10mm, Ball Nosed Cylindrical

Code: YRK2101246K

Uncoated Double cut (Cut 6): manufactured from high grade tungsten carbide for general-purpose use Chipbreaker (Cut 9): for use on cast iron, carbon steel, alloy steel 50RC and 60RC Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel up to HRC65 hardness Not suitable for milling large amounts of material Ideal for light stock removal at high rpms

In Stock

Description

Cylindrical Ball Nosed. | | All sizes are nominal with a 6mm shank unless other wise stated. | | Cut Numbers: | | Cut 3 – Rapid Cut. | for use on softer non ferrous and plastic materials, i.e aluminium, fibreglass, plastics, hard rubber and zinc alloy, | | Cut 6 – Double Cut. | Crosscut and double cut to improve control and chipbreaks. Manufactured from high grade tungsten carbide for general-purpose use. | | Cut 9 – Chipbreaker | Chipbreaker fast stock removal for improved control and reduced chips for use on hard materials, i.e. steel alloy 50RC, 60RC, carbon and cast iron. | | Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel etc. | up to HRC65 hardness. | | Please note: | • Work piece and tools should always be steady and well supported. | • Carbide burrs are not suitable for ‘milling’ large amounts of material, they are for light stock removal and high revolutions ‘LOW FEED – HIGH SPEED’. | • Always ensure that at least 70% of the shank length is clamped by the collet or chuck of the tool being used. | • Always ensure that the tool is rated to the recommended operating speed of the burr.

Additional information

Brand

Reviews

There are no reviews yet.

Be the first to review “Ball Nose Burr, Uncoated, Cut 6 – Double Cut, 10mm, Ball Nosed Cylindrical”

Your email address will not be published. Required fields are marked *