Carbide Burr, Uncoated, Chipbreaker, 3.0mm, Cylindrical Plain End

Code: KEN2100580K

Uncoated Rapid cut (Cut 3): for use on aluminium, fibreglass, plastics, hard rubber and zinc alloy Chipbreaker (Cut 9): for use on cast iron, carbon steel, alloy steel 50RC and 60RC Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel up to HRC65 hardness Not suitable for milling large amounts of material Ideal for light stock removal at high rpms

In Stock

Description

Cylindrical Plain End. | All sizes are nominal. Sizes marked * are 3mm shank, all others are 6mm shank. | | Cut Numbers: | Cut 3 – Rapid Cut | For use on softer non-ferrous and plastic materials, i.e. aluminium, fibreglass, plastics, hard rubber and zinc alloy. | Cut 9 – Chipbreaker | Chipbreaker fast stock removal for improved control and reduced chips for use on hard materials, i.e. steel alloy 50RC, 60RC, carbon and cast iron. | | Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel etc. | up to HRC65 hardness. | Please note: | Workpiece and tools should always be steady and well supported. | Carbide burrs are not suitable for ‘milling’ large amounts of material, they are for light stock removal at high rpm’s ‘LOW FEED – HIGH SPEED’. | Always ensure that at least 70% of the shank length is clamped by the collet or chuck of the tool being used. | Always ensure that the tool is rated to the recommended operating speed of the burr.

Additional information

Brand

Reviews

There are no reviews yet.

Be the first to review “Carbide Burr, Uncoated, Chipbreaker, 3.0mm, Cylindrical Plain End”

Your email address will not be published. Required fields are marked *